Confidential
USERS MANUAL
123(158)
Document number
Revision
1/198 17-4/FCP 101 3045 Uen
D
5.2.2 AT*EDCTR
Thirty-Two
Bit Internal Counter/Register
Description
Syntax
Possible responses
Sets a count in the 32-bit
counter register.
AT*EDCTR=<count><CR> OK
Displays the current value on
the 32-bit counter register.
AT*EDCTR?<CR> *EDCTR:
<count>
This command sets the internal 32-bit counter register value to <count>. To clear the 32-bit internal counter
register, use <count> = 0. A power on cycle or execution of the AT*EDCLR command sets the 32-bit internal
counter register to 0. A specific page command may be sent to the module to cause a power cycle while
preserving the current contents of the counter.
Defined parameter values:
<count> Range of the 32-bit counter register is 0..4294967295.
Note:
The 32-bit counter is intended to count transitions on a general-purpose input pin. Because the
CM52 does not currently support general-purpose I/O pins, this counter functions as a read-write
register. The counter value is never transmitted over the network in the current implementation. The
counter is retained for possible future use, and for test purposes.
The AT*EDCTR command will return ERROR if the feature required for this function is not enabled. Feature
required for this command:
o
Aeris Microburst
5.2.3 AT*EDMFE
MicroBurst
Function
Enable
Description
Syntax
Possible responses
Sets the MicroBurst mode
enable.
AT*EDMFE=<function>,<re
g>,<cnt>
OK
ERROR
Displays the MicroBurst mode
AT*EDMFE?
*EDMFE: <function>, <reg>,<cnt>,<SDCC
suppress>,<AUTH enable>,[,xxx
DISABLED]
This command configures the module to operate in the MicroBurst data mode, changes the registration mode,
and enables/disables the event counter. This non-volatile value is tested during power on cycle to establish the
MicroBurst defaults.
When MicroBurst is enabled via the AT*EDMFE command, the AT*EREGC command (Section 4.5.1) is
disabled, and all prior settings for the AT*EREGC command are ignored. The registration control functions are
overridden by the MicroBurst commands.
Parameter
Description
<function>
0
OFF. Disables the MicroBurst function.
1
ON. Enables the MicroBurst function including all overhead message paging.
2
ON. Enables the MicroBurst function and all overhead message paging.
Note:
this setting is retained for backward compatibility. Setting the value 2
results in setting a value of 1 internally, and the displayed value will be 1.
<reg>
0
Sets autonomous registration to EIA/TIA-553 specification.
1
Sets autonomous registration to Aeris’s specification.
Note:
Currently not supported.
2
Suppresses all autonomous registrations
