3
RF Exposure Requirements
To comply with FCC and Industry Canada exposure essential
requirements, a minimum separation distance of 20cm (8 inches) is
required between the equipment and the body of the user or nearby
persons.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning
: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures: (1) Reorient or relocate the receiving antenna. (2)
Increase the separation between the equipment and receiver. (3)
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. (4) Consult the dealer or an
experienced radio/TV technician to help.
Exigences en matière d'exposition aux radiofréquences
Pour satisfaire aux exigences essentielles de la FCC et d'Industrie
Canada concernant l'exposition, une distance minimum de 20 cm (8
pouces) doit être respectée entre l'équipement et l'utilisateur ou des
personnes se trouvant à proximité.
Recycling Information
This symbol on the product or on its packaging indicates
that this product shall not be treated as household waste.
Instead please deliver it to the applicable collection point
for the recycling of electrical and electronic equipment. By
recycling this product correctly, you will help conserve
natural resources and prevent potential negative
Summary of Contents for LPS-05WB-I
Page 1: ...Wireless Charger Important Product Information...
Page 8: ......
