Chapter 3 – Computer, PCIe Cards, and xMac mini Server Installation Steps
A – PCIe Cards Installation Steps
1.
Remove the xMac mini Server from its packaging, and then set it on a
flat, level surface.
2.
Loosen the two captive thumbscrews securing the top cover to the
rest of the enclosure
(Figure 1)
.
3.
Slide the top cover back and up to remove it
(Figure 1)
.
4.
Remove the strap securing the cables to the floor of xMac mini,
remove the loose Thunderbolt cable and set it aside, and then move
the rest of the cables aside
(Figure 2)
.
Support Note:
To avoid damaging components due to static
electricity discharge, wear an antistatic wrist strap while working
inside xMac mini Server.
Figure 1
Figure 2
4
WARNING:
When handling computer products, take care to prevent
components from being damaged by static electricity; avoid working
in carpeted areas. Handle expansion cards only by their edges and avoid
touching connector traces and component pins. Also, avoid touching the
xMac mini Server’s circuit boards and any of its components.
Support Note:
In order to install a PCIe card into slot 1, you will
need a short-handled Phillips screwdriver. In order to install a
card into slot 2, you will need either a standard 3/16" wrench, or a small
adjustable Crescent
®
wrench.
