27
CM-CU21 Configuration Options 2
Config Page 7 - Save/Load Configurations & Firmware Version
The last page allows you to save the current option settings to either of two
available backup sets that are unaffected by subsequent changes to the
option settings. The backup sets can then be reloaded when required. The
load/save functions will only work whilst in Page 7. Page 7 also shows the
current firmware version by flashing the Limit LED in a recurring sequence
i.e. 1 flash for version 1, 2 flashes for version2 etc.
To Save The Current Option Settings To Backup Set 1
Press and hold the Commentator 1 On Air and Talkback B buttons for 2
seconds. These buttons will then illuminate red to verify that the options
have been saved to backup set 1.
To Save The Current Option Settings To Backup Set 2
Press and hold the Commentator 2 On Air and Talkback B buttons for 2
seconds. These buttons will then illuminate red to verify that the options
have been saved to backup set 2.
To Load Backup Set 1 And Overwrite The Current Option
Settings
Press and hold the Commentator 1 On Air and Talkback A buttons for 2
seconds. These buttons will then illuminate red to verify that backup set 1
has been loaded.
To Load Backup Set 2 And Overwrite The Current Option
Settings
Press and hold the Commentator 2 On Air and Talkback A buttons for 2
seconds. These buttons will then illuminate red to verify that backup set 2
has been loaded.
To Exit Setup Mode
Press and hold the Commentator 1 and Commentator 2 On Air buttons for
3 seconds. When the power indicator stops flashing, the On Air buttons can
be released and the unit will enter normal operating mode.
In addition to being able to load and save options, it is also possible to
return the setup options to their factory default settings. Please note: all
changes made to the options settings will be lost. Loading of the factory
defaults does not affect the options stored in the backup sets.
To Return The Current Option Settings To Factory Defaults
Apply power to the unit whilst keeping Commentator 1 Talkback B and
Commentator 2 Talkback A buttons pressed for 5 seconds. These buttons
will then illuminate red to verify that the default options have been loaded.
After the default options have been restored, the unit will return to normal
operating mode.
