SonicWALL UMA EM5000, Getting Started Manual

Page: 54 / 98

SonicWALL UMA EM5000 Getting Started Guide Page 51
4. Type the SonicWALL GMS syslog server port in the GMS
Syslog Server Port field. The default port is 514.
5. Leave the box next to Send Heartbeat Status Messages
Only unchecked, unless you don’t want to receive reports
for this managed appliance.
6. If your SonicWALL UMA EM5000 appliance is directly
accessible from the SonicWALL NSA 2400 appliance,
leave the checkbox next to
GMS behind a NAT Device
unchecked. If your SonicWALL UMA EM5000 appliance is
not directly accessible from the SonicWALL NSA 2400
appliance, select the
GMS behind NAT Device checkbox
and type the WAN IP address of the gateway device in the
NAT Device IP Address field. Refer to the SonicWALL
GMS Administrator’s Guide for detailed information on
configuring your SonicWALL UMA EM5000 behind a NAT
device.
Tip:
If your gateway controller is running in transparent
mode, the WAN IP is the same as the LAN IP.
7. From the Management Mode drop-down box, select one
of the following methods of management: IPSEC
Management Tunnel , Existing Tunnel , or HTTPS . For
information on selecting a management method, refer to
GMS Gateway Recommendations - page 7.
• If the SonicWALL appliance will be managed through a
VPN management tunnel (default), select
IPSEC
Management Tunnel . The Inbound/Outbound SPI ,
Encryption Algorithms , Encryption Key, and
Authentication Key fields will appear, and each will
be populated. Alternatively, you can create your own
keys. The Encryption Key must be 16 characters long,
and the Authentication Key must be 32 characters
long.
Note:
Record your Encryption Key and Authentication Key.
You will need both keys when you add your appliance
for management using SonicWALL GMS.