19
Replace the Battery
l
When the sensor send the low battery voltage signal to main console. Please replace a
new battery for the sensor. In the main console, the LCD display shown the message as
below
Zone Address Setting
Enter the Installer password and the main console is in learning mode, after installing the battery on the
PIR. Set the power switch from “ OFF ” to “ C ” position. In the PIR panel, The red LED will blink for 1
sec, It means to transmit out a signal for 1 sec or to activate PIR sensor by detecting people pass by,
then the Main Console emits one ‘Beep’ and LCD displays ‘Sensor Added’, it means the PIR has
learned into the system successfully.
When main console is in armed mode, If PIR detects the movement of human or animals (cat,
dog), it will leave message on the LCD display as below.
Notes on the Position when Install
Motion sensors detect the movement of humans and animals within their range. In order to prevent
false alarms, we recommend that you do not install any motion sensor in the following areas:
Do not install any motion sensor in the following areas:
l
Where there is a device that causes rapid temperature change or rapid heat transfer. for
instance, near an air conditioner, fire place, heater or other intermittent heat sources.
l
Where the sensor will be exposed to direct sunlight.
l
Near large electrical devices and/or high output radio frequency sources, like the
refrigerator, microwaves computers, and light dimmers.
l
Where the effective range of the sensor is covered or blocked by furniture.
l
Where pets enter and exit freely, for instance - a cat or dog door.
l
Directly opposite any large object with flat reflecting properties, like large windows or
mirrors.
l
In a bathroom or other area that is exposed to moisture and extreme temperature change.
63 PIR SENSOR
01 Low battery
63 PIR SENSOR
01 Zone
