The standard output transformer has a Ni-Fe alloy core, but Creamer can be also ordered with 100% Fe or100% Ni transformers. Those can
even be combined on the 2 channels. This, along with a switchable solid- state balanced output, yields the final tone coloring. (Tip: If you prefer
a softer high end, try a 100% Fe output transformer.)
Addendum for Creamer SE:
The Creamer Special Edition offers a few improvements over the Plus version, while retaining the same sonic character:
All discrete signal path in both output modes (Creamer Std and Plus use a balanced line driver IC in SS mode)
Reduced current draw means less heating and even more stability
New bias circuit with 4 gain settings eliminates the need for pad
Even higher headroom
Soft clipping when overdriven
SOME REMINDERS REGARDING TUBES
Tubes work with very high supply voltages. There are points inside Creamer that measure in excess of 350V DC. If touched, those voltages
could be lethal!
Make sure that no pointed objects (especially metal) or liquids penetrate the inside of the unit through its cooling grilles or otherwise. If that
accidentally occurs, immediately pull the plug out of the power socket and wait for the unit to discharge. Creamer must not be operated if
moisture penetrates inside.
Before opening the unit (to change tube, wipe off moisture, etc) one must disconnect the mains cord and then wait several minutes for the
internal capacitors to discharge.
When mounting in a rack enclosure, always leave an empty space above the Creamer to ensure proper cooling.
Please do not replace the mains fuse with one of a higher value: use only 600mA@115V (500mA also works fine) (250 to 300mA@220-240V)
Legal Disclaimer
: Neither Sonic Farm nor anybody associated with it can take any liability for damage to persons or property caused by either
use, modification or servicing this unit.
HOW TO CHANGE TUBES
This only applies to a functional unit. Please entrust any repairs to qualified service personnel.
Only an EF-86 (or equivalent, like 6267, 6CF8 or Russian 6J32P) pentode can be used.
Pull out the power cord. Wait for at least 10 minutes for all the capacitors to discharge.
