S-50 DC
● S-80 DC ● S-110 DC ● S-120 DC – USER MANUAL
4
1
Safety
All persons involved in the transport, installation, operation, maintenance and repair of this system
must have read this user manual carefully.
The system and its accessories are in accordance with the current state of safety technology at
the time of delivery. Owing to the work processes involved, however, there may be parts of the system
and its peripherals which cannot be given optimum protection without an unreasonable reduction in
function and usability.
The following safety instructions must be complied with:
General instructions
Work on this system and its peripherals must only be performed by qualified and/or
trained staff. Other persons must be kept away.
This user manual must be available for the supervisory, operating and maintenance staff
to refer to.
Improper use may endanger life and limb, the system and connected equipment, as well
as the efficient functioning of the system.
Always use correct tools in perfect condition.
Checks must be made to ensure that the relevant safety regulations are being complied
with.
Only operate the system if it is in technically perfect condition.
No non-original parts may be used for the system and its peripherals, as the necessary
safety will not be guaranteed. No mode of working which detracts from the safety of the
system must be used.
The user is under an obligation to report any changes in the system to the supervisor
responsible without delay.
Electrotechnical instructions
The system and all additional equipment must be connected properly. The relevant
regulations must be complied with.
Maintenance work must only be carried out when the system is switched off (dead) and
then only by qualified and/or trained staff.
1.1
Warnings
Important instructions concerning personal protection, work safety and technical safety are indi-
cated as follows:
WARNING
Warning indicates work and operating procedures which must be complied with
in full to exclude the possibility of persons being put at risk. This includes in-
structions concerning particular dangers when handling the system.
NOTE!
Attention indicates work and operating procedures which must be complied with in full
to prevent the system/peripherals from being damaged or destroyed.
The note indicates special technical requirements to which the user must pay particu-
lar attention when using the system.
