Caution: Risk of electric shock!
Do not attempt to disassemble of modify the unit or its accessories. In case any part is damaged,
immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the
manufacturer, its service facility or similarly qualified personnel.
FEATURES
fan blade: 40 cm • adjustable output (3 speed) • fixed position or rotating (90°) • controllable height (100 - 130 cm) • controllable dip angle • mesh grill • white
ASSEMBLY
1. Remove the plors or knife.
2. Attach the rear grill to the motor.
3. Afterwards screw on the grill fastening nut.
4. Attach the fan blade to the spindle then fasten it with the fastening nut.
5. Then attach the front grill to the fan and tighten the bolt (1)
6. Assemble the stand following the directions below and mount the fan on it.
ASSEMBLY OF THE STAND
1. Join the two parts of the base
2. After this screw the assembled base to the plastic part to the lower part of the stand (13). (According
to the pictures)
3. Set the desired height of the stand, and fix it using the strainer ring (12)!
4. Now put the assembled cooling fan unit on top of it, and fix the same using the bolt!
OPERATING THE FAN
You can adjust the fan after assembling it with the buttons on the control panel. To select the desired speed you can use the I/II/III buttons, and the fan can be turned off
with the O button.
You can use the button at the top of the fan to start or stop the rotating movement. When pressed, the fan will rotate from side to side; when pulled out, the rotating
movement will cease.
CLEANING & MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
1. Switch off and power off the unit by unplugging it from the electric outlet prior to cleaning.
2. Warning: Only remove the front protective grille from the fan if it has been powered off.
3. Use a slightly moistened cloth to clean the unit’s exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of
the appliance.
4. Warning: Only replace the front protective grille on the fan if it has been powered off.
5. Only power on the fan after this has been done.
TROUBLESHOOTING
SPECIFICATIONS
power supply: 230 V ~ / 50 Hz
3
maximum air mass volume: F = 50,0 m /min
fan input power: P = 45,0 W
3
service value: SV = 1,11 (m /min)/W
power consumption during standby: P = 0,0 W
SB
fan acoustic power level: L = 70 dB (A)
WA
maximum air speed: c = 4,8 m/sec
length of power cable: 1,4 m
fan blade diameter: 40 cm
fan height (adjustable): 100 – 130 cm
Cause
Solution
The fan does not turn on
Check the power supply
Check the switches
The fan does not rotate
Check the rotation control