21
EN -Functions / H - Funkciók / SK - Funkcie / RO - Funcţii / SRB-MNE - Funkcije / CZ - Funkce /
HR-BIH - Funkcije
AROMA DIFFUSER
FEATURES
Ultrasonic cold mist humidifier, aroma diffuser, with warm white mood light.
● quality materials used: rubberwood base, china cover ● water tank capacity: 280 ml ● humidification: 15-20 ml / h ● continuous or
intermittent humidification (30 sec on/ 30 sec off) ● selectable off timer setting of 1, 3, or 8 hours ● amber LED indicator lights ● warm white
mood light with two brightness levels or soft pulsed light ● gradual fade out to help falling asleep (30 minutes) ● when water runs out, or
after the timer setting humidification stops and lights turn off together, or independently
FUNCTIONS
Humidifier button
number of button presses
function
indicator
1x
continuous humidification
2x
humidification for 1 hour
3x
humidification for 3 hours
4x
humidification for 8 hours
5x
humidification off
By pressing and holding down the mist button for 2 seconds, the device switches to intermittent humidification mode (30 sec ON / 30 sec OFF), indicated
by the indicator lights. To return to continuous operation, press and hold down the mist button again for 2 seconds. This change of operation mode does
not influence the timer setting.
Lamp button
number of button presses
function
1x
higher brightness
2x
low brightness
3x
soft pulsed light
4x
turn lights off
Sleeping mode
Press and hold down the lamp button (11) during high or low brightness setting, the 3 LED lights will flash one after the other. The light will gradually
fade out, then turn off during the next 30 minutes. To exit sleeping mode shortly press the lamp button (11) again
Setting separate night-light
By default, the lamp function of the device turns off along with humidification in case of a timer setting, or when water runs out.
To turn on the lamp
independently
, simultaneously press and hold down both buttons, until the two LED lights to the left start flashing alternately.
In this mode, if humidification stops due to a timer setting or lack of water, the lamp will continue to operate.
To turn off the lamp together with humidification, simultaneously press and hold both buttons again, until the two LED lights to the right start flashing
alternately.
FILLING THE WATER TANK
Caution! Before filling the water tank, disconnect power supply from the device by disconnecting the mains plug! Fill up the water tank as instructed in
points 3-6 of the
Commissioning
section. Too cold or hot water hinders vapour production and can also cause damage to the device.
EMPTYING THE WATER TANK
Caution! Before emptying the water tank, disconnect power supply from the device by disconnecting the mains plug!
Only pour out water towards the side, where the
MAX
mark is located, as water should not get into the air vent.
Figure 2. b)
TECHNICAL SPECIFICATIONS
Power supply, mains power adapter: .......................... PRI: 230 V~ / 50 Hz SEC: 24 V / 0.5 A
Length of power cable: ............................................... 1.8 m
Water tank volume: ..................................................... 280 ml
Humidification: ............................................................ 15 – 20 ml/hour, depending on operation mode and environment
Ambient temperature: ................................................. 5-40 °C
Dimensions: ................................................................ ø146 x 132 mm
