2. When the desired quantity of coffee has flown out (in case of 2 portions – up to marking 2nd, by 4 portions to marking 4th), switch the mode selector to PAUSE position.
3. Fill a metal or porcelain mug with semi-cold milk.
4. Immerse the milk frothing nozzle directly below the surface of the milk and turn the switch into [gőzlöket piktogram] position.
5. Move the mug with circular motions, approx. for 30 seconds while the nozzle is under the surface of the milk.
6. When the volume of milk has doubled, lower the nozzle into the milk to warm it up.
7. Close the steam by turning the switch to PAUSE position. Now you can take away the milk from the nozzle.
8. Release the overpressure according to the paragraph „Control and dissemination of overpressure”.
Now you’re ready to compile cappuccino. Up to the first 1/3 of the mug fill it with coffee, then pour the same quantity of steamed milk on it. Finally spoon milk foam on the top.
CLEANING, MAINTENANCE
1. You can clean inside of the nozzle directly after making the milk foam, if you let out steam to a half glass of water.
2. Before further cleaning, switch off the appliance, then power it off by unplugging it from the wall outlet.
3. Let the appliance to cool down (min. 10 minutes).
4. Make sure, that there is no overpressure in the appliance. See the paragraph about „Control and dissemination of overpressure”.
5. Always remove the coffee ground after use. Wash up the filter, the filter holder, the glass carafe, the drip tray and the grill with hands.
6. Do not place the filter holder in place unless you making coffee. Thus, the seal does not run unnecessarily.
7. Clean the milk frother nozzle carefully, the spout can be hot.
8. Use a slightly moistened cloth to clean the unit’s outer surface. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the
appliance! Appliance must not be immersed to water!
Descaling
It is recommended to remove limescale once a month in case of hard water, and once in every 2 months in case of medium-hard water or soft water.
1. Pour an amount of glass carafe undiluted household vinegar to the water tank of the cooled, non-pressurized device.
2. Leave the appliance overnight and pour the vinegar into the sink by turning the appliance upside down.
3. Fill up the water tank halfway with cold drinking water and after pour the water to the sink. Repeat this step twice.
4. After the water tank is free from limescale, fill an amount of glass carafe of undiluted household vinegar into the water tank.
5. Close the water tank tightly. Put back the filter holder with the filter, and then place the glass carafe with the lid under the filter holder.
6. Switch the unit to position.
7. After the vinegar has passed through the appliance, pour it out of the glass carafe into the sink.
8. Repeat steps from 4 to 7 with clear water until you feel no more vinegar smell. Wait 10 minutes between the cleaning cycles and always check that the appliance is free of
overpressure before opening the water tank.
9. By following the steps of INSTALLATION, the coffee machine is ready to use again.
TROUBLESHOOTING
Malfunction
Solution
The appliance does not make coffee.
Check the power supply and the main switch.
Fill water to the water tank.
Use less or more roughly ground coffee.
Cover of the filter holder and the water tank has to properly fit to its place.
Steam does not develop.
Pout little quantity of water to the water tank. If the water is too much, then pour
out from it.
Waste equipment must be collected and disposed separately from household waste because it may contain components hazardous to the environment or health. Used
or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of product
at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself. If you have any
questions, contact the local waste management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and
shall bear any associated costs arising.
TECHNICAL DATA
power supply: . . . . . . . . . . . . . . . . . .230 V~ / 50 Hz
output: . . . . . . . . . . . . . . . . . . . . . . . .800 W
dimensions: . . . . . . . . . . . . . . . . . . . .17 x 32 x 23,5 cm
water tank capacity: . . . . . . . . . . . . .240 ml
type of glass carafe: . . . . . . . . . . . . .HG PR 14/K
weight: . . . . . . . . . . . . . . . . . . . . . . . .2,0 kg
length of power cable: . . . . . . . . . . . .75 cm
Summary of Contents for Home HG PR 14
Page 27: ......
