4
22.
It is STRICTLY PROHIBITED to install or use the appliance in zones 0 and 1 of premises containing
bathtubs or showers (see Figure 3)!
23.
All circuits in premises containing bathtubs or showers shall be protected with one or more RCDs with a
rated triggering current of up to 30 mA!
24.
Observe the local or special national regulations when installing an appliance in premises containing
bathtubs or showers.
25.
It is prohibited to use the appliance in motor vehicles or in confined spaces such as elevators.
26.
When planning not to use the unit for an extended period of time, switch it off then remove the power plug
from the outlet. Store the appliance in a cool, dry place.
27.
Always remove power from the heater before relocating it.
28. Do not locate the appliance directly below a wall outlet.
29.
If any irregular operation is detected (e.g., unusual noise or burnt odor from unit), immediately switch it off
and remove the power plug.
30.
Make sure that no foreign objects or liquid can enter the unit through the openings.
31.
Protect from dust, humidity, sunlight and direct heat radiation.
32.
Power off the unit by unplugging it from the electric outlet prior to cleaning.
33.
Do not touch the unit or the power cable with wet hands.
34.
The appliance may only be connected to properly grounded 230 V~ / 50 Hz electric wall outlets.
35. Unwind the power cable completely.
36.
Do not use extension cords or power strips to connect the unit.
37.
Do not lead the power cable on top of the appliance or near the heat radiating surface.
38. The appliance should be located so as to allow easy access and removal of the power plug.
39.
The unit is intended for household use. No industrial use is permitted.
40.
Due to continuous improvements, the technical data and design may change without any prior notice.
41.
The actual instruction manual can be downloaded from
www.somogyi.h
u website.
42.
We don’t take the responsibility for printing errors which may occur, and apologize for them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged,
immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer,
its service facility or similarly qualified personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE OR ELECTRIC SHOCK.
INSTALLATION
1.
Before installation, carefully remove the packaging material, making sure no to scratch the unit or its power
cable. In case of any damage, the unit must not be operated.
2.
It is STRICTLY PROHIBITED to install or use the appliance in zones 0 and 1 of premises containing
bathtubs or showers
(see Figure 3.)
.
3.
All circuits in premises containing bathtubs or showers shall be protected with one or more RCDs with a
rated triggering current of up to 30 mA.
4.
To ensure proper operation, you have to arrange for the free circulation of hot air. Therefore, pleas, select
the location of the unit on the wall according to
Figure 2
. It is forbidden to mount the unit directly below a
power socket.
5.
Mount the two supplied consoles on the back of the product with the 4 small screws.
6.
Put the product against the wall and mark the holes, then drill them.
7.
Mount the unit on the wall using the enclosed dowels and bolts.