5
22. When disposing of the heater, the provisions for disposing of the oil must be followed.
23. If any irregular operation is detected (e.g. unusual noise or burnt odor from the unit), immediately switch
it off and unplug it!
24. Make sure that no foreign objects or liquid can enter the unit through the openings.
25. Protect from dust, humidity, sunlight and direct heat radiation!
26. Unplug the unit from the mains before cleaning!
27. Never touch the appliance and the power cable with wet hands!
28. The appliance may only be connected to properly grounded 230 V~/50 Hz electric wall outlets!
29. Unwind the power cable totally!
30. Do not lead the power cable on the appliance!
31. Do not lead the power cable under carpets, doormats, etc.!
32. Do not use extension cords or distributors to connect the unit!
33. The appliance should be located so as to allow easy access and removal of the power plug!
34. Lead the power cable so as to prevent it from being pulled out accidentally or tripped over!
35. The unit is for household use only, no industrial use is permitted!
36. Due to continuous improvements, the technical data and design may change without any prior notice.
37. The actual instruction manual can be downloaded from www.somogyi.hu website.
38. We don’t take the responsibility for printing errors which may occur, and apologize for them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged,
immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer,
its service facility or similarly qualified personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE OR ELECTRIC SHOCK.
INSTALLATION
1. Before switching on for the first time, carefully remove the packaging material taking care not to damage
the appliance and power cable. Do not use the product if it is damaged in any way!
2. The device may only be used in dry indoor conditions!
3. Remove the appliance from the box. Then turn it on top and place it on a solid, horizontal surface. Do not
power it on in this state!
4. Screw the supplied soles onto the bottom of the heater. (
2. figure
)
5. Stand the appliance on its soles on a solid, horizontal surface!
6. For wall-mounted use, fix the heater on the wall without soles, with the included wall brackets. (
2. figure
)
a.
Fix the brackets to the wall with wall dowels and 2-2 screws. During installation, make sure that the
springy, openable part of the brackets are at the appliance’s top. Use dowels that fit the wall structure
and the size of the screws. Make sure the brackets are standing vertically!
b.
Carefully place and hook the bottom edge of the appliance into the brackets’ lower arm, then hook the
the brackets’ upper, springy part into the appliance’s upper edge.
c.
Check that the device is stable on the wall!
7. For the operation, the free flow of hot air must be ensured, so take into account the minimum placement
distances shown in
3. figure
. Wait 2-3 minutes!
8. The appliance’s main switch (2) must be in switched off state!
9. Connect the appliance to a standard grounded wall outlet! This makes the appliance ready for use.
