SAFETY INSTRUCTIONS
Page 8
Danger of injury due to unexpected actuation!
Switch off the machine before setup work, maintenance, repairs and troubleshooting, and
protect against unexpected restarting.
Disconnect the mains plug of the machine.
DANGER
Risk of explosion!
The machine is not explosion-protected as a factory standard. Accumulations of dust can
cause an explosive atmosphere.
Do not use the machine in areas with a potentially explosive atmosphere.
Ensure sufficient ventilation of the room, as crushing causes dust accumulations.
Ensure good ventilation of the machine to avoid an explosive atmosphere building up.
Regularly clean the machine (especially the drive motor) to avoid a layer of dust
accumulating.
DANGER
Risk of fire due to V-belt slipping!
Slipping belts can overheat and cause fires
Make sure the V-belts are tensioned correctly.
Comply with maintenance intervals. First check of V-belt tension after 10-20 hours of
operation, then extend the interval gradually to 3-6 months.
WARNING
Risk of injury due to trapping or pulling in!
Do not wear loose-fitting clothing.
Do not wear ties, necklaces, shawls, scarves or similar.
Tie back long hair (e.g., use a hair net).
WARNING
Risk of crushing, drawing in!
In particular, on the pinch rollers and drive parts (belts and gears, etc.).
Do not reach into rotating/moving machine elements or devices.
Do not reach into the outlet while the machine is running.
WARNING
Parts being ejected!
There may be foreign bodies in the milled material (e.g. ball bearings). During crushing, they
may be propelled upward and out of the hopper with unexpected force by the pinch rollers,
thus causing serious injury.
Do not bend over the feed hopper on the machine during operation.
Remove any foreign bodies that accumulate from the machine (e.g. foreign body ejector).