C Copyright Somfy Systems, Inc. 11/16
Ref. No. 25004850
SOMFY SYSTEMS INC
SOMFY NORTH AMERICAN HEADQUARTERS
121 Herrod Blvd., Dayton, NJ 08810
P: (800) 22-SOMFY (76639)
NJ: (609) 395-1300
F: (609) 395-1776
FLORIDA
6100 Broken Sound Pkwy. N. W.
Suite 14, Boca Raton, FL 3487
P: (800) 22-SOMFY (76639)
F: (561) 995-7502
Somfy Systems, Inc. reserves the right to change, update or improve this document without prior notice.
CALIFORNIA
15291 Barranca Parkway
Irvine, CA 92618-2201
P: (800) 22-SOMFY (76639)
F: (949) 727-3775
SOMFY ULC
SOMFY Canada Division
5178 Everest Drive Mississauga, Ontario L4W2R4
P: (800) 66-SOMFY (76639)
CN: (905) 564-6446
F: (905) 238-1491
ADDITIONAL PROGRAMMING INSTRUCTIONS
MOTOR COMPATIBILITY
ORDERING INFORMATION
A. RTS Transmitter
B. SDN Addressees
PROGRAMMING ADDITIONAL RTS TRANSMITTERS:
Press and hold the programming button of a Telis Transmitter previ-
ously memorized by the RTS Receiver until the LED on the receiver turns on. Press and release the programming button on
the new transmitter or channel. The LED on the receiver will turn off, indicating this transmitter has been memorized. Repeat
this procedure for each transmitter or channel, up to 5 total.
DELETING AN RTS TRANSMITTER FROM MEMORY:
Press and hold the programming button of a Telis Transmitter pre-
viously memorized by the RTS Receiver, but not the one to be removed from memory. Continue holding the button until the
LED on the receiver turns on. Press and release the programming button on the transmitter or channel to be removed from
memory. The LED on the receiver will turn off, and that transmitter will no longer operate the RTS receiver.
CHANGING SDN GROUP ADDRESSES:
Connect the RTS Receiver to a computer running the Somfy configuration software.
Select correct com port, then click on connect. Enter the RTS Receiver address next to “Get MTR Addr”. Click on Single then
“Get Group Addr”. New addresses can be entered in positions 1 - 5. Click on “Set” to confirm.
REMOVING ALL RTS TRANSMITTERS and GROUP ADDRESSES:
Press and release the reset button on the RTS Receiver.
The LED will turn on, indicating that no transmitters or group addresses are memorized.
The RTS Receiver for SDN is compatible with the following motors:
NOTE: Systems that include the Sonesse 50 ILT or the LT50 ILT series motors should not use this product. Please use RTS Receiver
(for Legacy ILT Motors) Part #1822541.
Systems that include the animeo IP Building Controller should not use this product. Please use RTS Receiver for animeo IP
Part #1822447.
Sonesse
®
50 RS485 (AC)
Sonesse
®
50 RS485 (DC)
LT50 RS485 (AC)
Sonesse
®
30 RS485 (DC)
RTS Receiver for SDN
USB to RS485
Bus Power Supply
1822294
9015260
1822440
DESCRIPTION
PART NUMBER
