Rollixo RTS
20
Copyright © 2012 Somfy SAS. All rights reserved
EN
Indicator light status
Diagnostics
Consequences
Actions/troubleshooting
Prog
optical wired
safety edge
Optical wired safety edge
failure
Opening ok
Closed by pressing
and holding down
- Check the type of safety edge connected (optical wired
safety edge, dipswitch no.4 set to OFF); if the wired safety
edge is resistive, move dipswitch no.4 to ON.
- Check the safety edge wiring (see page 14).
- Check that no radio safety edge transmitter is memorised in
the receiver. If a radio safety edge transmitter is memorised
in the receiver, clear it (see page 19).
Resistive
wired safety
edge
Resistive wired safety
edge failure
Opening ok
Closed by pressing
and holding down
- Check the type of safety edge connected (resistive wired
safety edge, dipswitch no.4 set to ON); if the connected
safety edge is resistive, move dipswitch no.4 to OFF.
- Check the safety edge wiring (see page 14).
- Check that no radio safety edge transmitter is memorised in
the receiver. If a radio safety edge transmitter is memorised
in the receiver, clear it (see page 19).
Radio safety
edge
Radio safety edge failure Opening ok
Closed by pressing
and holding down
See radio safety edge transmitters for diagnostics (see pages
20 and 21).
Repeat the safety edge transmitter memorisation procedure
on the receiver (see page 18).
Radio interference on the
safety edge transmitter
Opening and
stopping ok
Closed by pressing
and holding
down: the closing
movement will
automatically
resume when the
radio interference
disappears.
If a powerful radio system is present on the site (infrared
detector, TV transmitter, etc.) and is transmitting on the same
frequency, the receiver will wait for the transmission to end to
before controlling the door again.
Magnets missing if the
resistive safety edge
transmitter is installed
Opening ok
Closed by pressing
and holding down
Check for the presence of magnets and install them if required
(see pages 9 and 10).
End of life of the safety
edge transmitter batteries
Opening ok
Closed by pressing
and holding down
Safety edge transmitter low battery indication.
If the fault persists, replace the safety edge transmitter
batteries.
Obstacle detection
Remove the
obstacle by
automatic partial
opening
Check that no obstacle is causing the safety edge to detect.
Photoelectric
cells
Cell fault
Opening ok
Closed by pressing
and holding down
If no cells are installed, check that the connector (terminals 18
and 19) is bridged.
If cells are installed:
- Check that no obstacle is cutting across the cell beam
- Check the position of dipswitch no.2 in accordance with the
type of cell (see page 12).
- Check the cell wiring (see page 13).
Bridged cell connector
Opening ok
Closed by pressing
and holding down
If no cells are installed and cell connectors are bridged
(terminals 18 and 19), check that dipswitch no.1 is set to OFF.
Obstacle detection
Remove the
obstacle by full
automatic opening
Check that no obstacle is cutting across the cell beam
Radio
Radio frame received from
a recognised transmitter
Resistive safety edge transmitter (EsE)
Press the button on the back of the transmitter once.
The transmitter indicator light will come on:
If the indicator light flashes:
6 times → the safety edge is faulty (short-circuit).
8 times → the safety edge has not been correctly lengthened (open circuit).
