SOMFY Oximo 40 io, Instructions Manual

Page: 13 / 21

2
EN
Copyright © 2016 Somfy SAS. All rights reserved Images not contractually binding
1.2
LIABILITY
Please read these instructions carefully before installing and using the drive. In addition to following the
instructions given in this guide, the instructions detailed in the attached
Safety instructions document
must also be observed.
The drive must be installed by a motorisation and home automation professional, according to instructions
from Somfy and the regulations applicable in the country in which it is commissioned.
It is prohibited to use the drive
RXWVLGHWKH¿HOGRIDSSOLFDWLRQGHVFULEHGDERYH6XFKXVHDQGDQ\IDLOXUH
to comply with the instructions given in this guide and in the attached Safety instructions document,
absolves Somfy of any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the drive
and
must provide them with the instructions for use and maintenance, and the attached Safety instructions
document, after installing the drive. Any After-Sales Service operation on the drive must be performed by
a motorisation and home automation professional.
If in doubt when installing the drive, or to obtain additional information, contact a Somfy adviser or go to
the website www.somfy.com.
2. INSTALLATION
Instructions which must be followed by the motorisation and home automation professional
installing the drive.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each motorisation.
2.1. INSTALLATION
2.1.1. Preparing the drive
Check that the inner diameter of the tube is 37 mm or
greater.
1)
Fit the accessories required to integrate the motorisation in
the roller tube:
‡(LWKHU¿WWKHGULYHZKHHO
a
on the drive.
‡2U¿WWKHFURZQ
b
and the drive wheel
c
on the drive.
2)
Measure the length (L1) between the inner edge of the
motorisation head and the rim of the drive wheel.
2.1.2. Tube preparation
3) Cut the roller tube to the required length, depending on the
motorised product.
4) Deburr the roller tube and remove the swarf.
5) For smooth roller tubes, cut a notch with the following
measurements:
3)
1) 2)
d
e
1
1
1
1)
L1
L1 =
L1
L1 = …
2)
Ø > 37 mm
c b
L1
L1 =
Ø = 37 mm
a
d e
Ø 40 x 1 6 mm 8.5 mm
Ø 40 x 1.5 7 mm 8.5 mm
1
Safety warning! Information
1
Caution!