SOMFY LT50 CMO, Installation Manual

Page: 13 / 36

Copyright © 2007-2016 Somfy SAS. All rights reserved.
LT 50 CSI - LT 60 CSI
13
EN
6$)(7<
*HQHUDOVDIHW\DGYLFH
1) Never immerse the motor in liquid!
2) Avoid impacts!
3) Do not drop it!
4) Never drill holes in the motor!
5) Always make a loop in the power supply cable
to prevent water entering the motor!
This Somfy product must be installed by a professional motorisation installer, for whom these instructions
are intended.
1HYHUEHJLQLQVWDOOLQJZLWKRXW¿UVWFKHFNLQJWKHFRPSDWLELOLW\RIWKLVSURGXFWZLWKWKHDVVRFLDWHGHTXLSPHQW
and accessories.
These instructions describe how to install, commission and use/operate this product.
Moreover, the installer must comply with current standards and legislation in the country in which the
product is being installed, and inform his customers of the operating and maintenance conditions for the
product.
$Q\ XVDJH RXWVLGH RI DSSOLFDWLRQV GH¿QHG E\ 6RPI\ FRQVWLWXWHV QRQFRPSOLDQFH DQG LV WKHUHIRUH QRW
covered by the guarantee. In this event, as for all usage not consistent with the instructions given herein,
Somfy accepts no responsibility for harm or damage.
2SHUDWLQJFRQGLWLRQV
- Check that the motor has been supplied with the protective housing and, optionally, with the adjustment
pull tabs.
-
8VH D FUDQN KDQGOH DQG HPHUJHQF\ FUDQN ¿WWHG ZLWK D PP VTXDUH SLQ RU PP KH[DJRQDO SLQ
(accessories not supplied).
,167$//$7,21
0RWRUSUHSDUDWLRQ
1) Fit the crown (A) and drive wheel (B) to the motor.
2) Measure the length (L1) between the motor head and the
end of the drive wheel.
7XEHSUHSDUDWLRQ
1) Cut the roller tube to the required length.
Deburr the roller tube and remove the swarf.
2) For smooth roller tubes, cut a notch with the following
measurements:
e h
LT 50 CSI
LT 60 CSI 4 mm (0.16 in)
25 mm (0.98 in)
8 mm (0.32 in)
35 mm (1.38 in)
1 2
3
4
5
1
2
A
B
L1
L1
1
2
e
h
6SHFL¿FVDIHW\DGYLFH
-
8VHDFRQWUROSRLQWZLWKD¿[HGSRVLWLRQRUPRPHQWDU\DFWLRQW\SHVZLWFK
- Never connect two control points to a single motor.
- Never connect two motors to a single control point.
- Do not use a lighting control point.