24 Vdc
+
_
D C Motors
D C Motors
24 Vdc
+
_
Individual Control
Individual Control
IRS 300
IRS 300
General Control
2
Installation :
Mounting :
A
The IRS 300 has to be installed indoor.
1. Drill a hole in the wall at the desired location using a 5mm drill bit
(depth 25mm) and insert the supplied raw plug.
2. Place the screw supplied into the securing hole on the face of the
IRS 300 and feed into the raw plug.
3. Fix the IRS 300 unit by securing the screw.
SCREW
IRS 300
WALL
RAW PLUG
IRT 103
-
To tilt the slats, press and hold one of the corresponding buttons (up or down).
To raise or lower the blind, momentarily press the corresponding button (up or down).
To stop the blind press the stop button.
IMPULSE
-
To raise or lower the blind, momentarily press the corresponding button (up or down).
SWITCH
To stop the blind, press the stop button or push the up and down buttons simultaneously.
IRT 803
-
To tilt the slats, press and hold one of the corresponding buttons (up or down).
To raise or lower the blind, momentarily press the corresponding button (up or down).
Point the transmitter at the Infra-red sensor which corresponds to the receiver you wish to control.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
If you wish to control one
receiver, press the
corresdponding button of the
channel you have selected.
Then you can control the
receiver by pressing the
buttons :
UP
,
DOWN
or
STOP
.
3
4
5
6
7
8
1
➟
8
1
➟
4
5
➟
8
If you wish to control a
group of receivers, press on
the corresponding button :
1..4
5..8
1..8
>
>
R
Operation :
C
Wiring :
B
