E
nter the programming mode
Press and hold for at least 5 seconds the « prog » button on the IRT 803 transmitter.
The blind concerned, at it alone, will start to tilt up & down quickly.
Warning : If you use the IRT803, it is necessary to « lock » the receivers which are not being programmed by operating
them in either UP or DOWN direction (they will be locked for 3 minutes and it is impossible to enter in the programming
mode by the IRT803). To unlock them, give a STOP order.
PROG.
1
➟
8
1
➟
4
5
➟
8
®
E
xit from the programming mode
Press momentarily the « prog » button on the IRT 803 transmitter. The blind stops
tilting.
PROG.
1
➟
8
1
➟
4
5
➟
8
®
3
Important : Carry out this operation as near as possible to the receiver of the blind that you wish to program.
PROG.
1
➟
8
1
➟
4
5
➟
8
®
3
4
5
6
7
8
1
➟
8
1
➟
4
5
➟
8
3
4
5
6
7
8
1
➟
8
1
➟
4
5
➟
8
Enter the
programming mode.
The blind starts
tilting up & down.
Press the 8 button.
The blind stops
tilting.
Press the button
Exit the programming
mode by pressing the «
prog » button
.
1..8
To cancel and revert back to IRT 103 transmitter operation
.
a
>
>
PROG.
1
➟
8
1
➟
4
5
➟
8
®
1
2
3
4
1
2
3
4
5
6
7
8
Enter the
programming mode.
The blind starts
tilting up & down.
Press the 1 button.
The blind stops
tilting.
Press the corresponding
button of the desired
channel (1, 2......8).
How to choose a channel (IRT 803 only
)
:
b
>
>
The channel is now
assigned. The blind will
start tilting up & down
quickly again.
Proceed with another
setting for this blind or
exit the programming
mode.
>
PROG.
1
➟
8
1
➟
4
5
➟
8
®
1
2
3
4
5
6
7
8
2
4
6
Enter the
programming mode.
The blind starts
tilting up & down.
Press the 5 button.
The blind starts tilting
slowly.
To set tilting speed:
Increase speed by pressing up.
Decrease speed by pressing
down.
How to set the tilting speed
:
c
>
>
Press the button
to confirm.
The blind starts tilting up
& down quickly again.
Proceed with another
setting for this blind or
exit the programming
mode.
>
5..8
Programming :
R
