![background image](http://html1.mh-extra.com/html/somfy/heating-slim-receiver-rts-2kw/heating-slim-receiver-rts-2kw_installers-manual_1318146031.webp)
EN
Copyright © 2010 Somfy SAS. All rights reserved.
Heating Slim Receiver RTS 2kW / Heating Slim Receiver RTS 2kW Plug
5
Pressing a button on the
control point has no effect
on the heating ramp.
The control point has not been
programmed into the Heating Slim
Receiver RTS 2kW.
Follow the procedure for adding
an RTS control point - see section
entitled "Adding/Removing
RTS control points".
The batteries in the control point are
weak.
Replace the batteries, using the same
battery model.
Radio interference prevents the
operation of the RTS control point and
Heating Slim receiver RTS 2kW.
Turn off any radio equipment nearby.
The control point used is not compatible
with the Heating Slim Receiver RTS
2kW.
Ensure the two products are
compatible.
Nothing operates
The power supply is faulty.
Check the power supply.
One or more heating lamps is blown.
Replace the heating lamp(s).
The heating lamp or lamps linked to the
Heating Mod/Var Receiver RTS 2kW are
in excess of 2000 W.
Use a more powerful heating receiver.
7.2. Replacing a lost or broken control point
This reset is carried out if all the RTS control points
have been lost or broken.
Only switch off the power to the Heating Slim
Receiver RTS 2kW to be reset!
Cut the power supply for 2 seconds.
1)
Switch the power supply back on for approximately
2)
10 seconds (at least 5 seconds but no more than 15
seconds).
Cut the power supply for 2 seconds.
3)
Switch the power supply back on: the heating lamp
4)
3
ashes slowly.
Brie
3
y press the PROG button on the new RTS control
5)
point: the heating lamp will come on then go out to
indicate that the new RTS control point has been
programmed into the Heating Slim Receiver RTS
2kW.
7.3. Restoring the original con
guration
This reset removes all control points.
Only switch off the power to the Heating Slim
Receiver RTS 2kW to be reset!
Cut the power supply for 2 seconds.
1)
Switch the power supply back on for approximately 10
2)
seconds (for at least 5 seconds but no longer than 15
seconds).
Cut the power supply for 2 seconds.
3)
Switch the power supply back on: the heating lamp
4)
3
ashes slowly.
Press the PROG button on the RTS control point until
5)
the heating lamp comes on then goes out twice in
succession: all control points have been removed.
Follow the procedures in the section entitled
-
“Commissioning” to add RTS control points.
5
3
1
2
OFF
OFF
ON
2 sec.
2 sec.
10 sec.
p
PROG.
o
o
q
4
ON
5
3
4
1
2
OFF
OFF
ON
ON
2 sec.
2 sec.
10 sec.
m
PROG.
m
n
Summary of Contents for Heating Slim Receiver RTS 2kW
Page 87: ......