SOMFY Glydea Ultra RTS Series, Instructions Manual

Page: 4 / 128

4
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme . All rights reserved
.
EN

2. INSTALLATION
Instructions which
must be followed by the drive and home automation professional installing the Glydea
Ultra motor.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.
2.2. WIRING
(Fig C)
Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
Leave the drive power supply cable accessible: it must be possible to replace it easily.
-
Switch off the power supply.
-
Connect the drive according to the information in the table below:
AC wiring
(Fig C1)
DCT wiring (Fig C2)
Drives equipped with a US power plug
(Fig C3)
Compatible controls - Wiring of control (Fig D)
1) Setting tool
2) Centralis IB
3) 2 NO (Normally Open) Dry contact switch
2.3. COMMISSIONING
2.3.1. Pre-programming the RTS control point (only for RTS version) (Fig E)
1)Switch on the power supply
2) Press the
Open and Close buttons on the RTS control point at the same time: The motorised product moves up and
down, and the RTS control point is pre-programmed in the motor.
2.3.2. Setting the end limits
At the first command Open or Close, the motorised product make a first run to record the hard stop position.
2.1. INSTALLATION
2.1.1. Installation of the rail (Fig A)
1) Mark the position of the brackets.
2) Drill the ceiling or the wall at the right places.
3) Attach the brackets.
4) Attach the rail on the brackets.
2.1.2. Installation of the motor (Fig B)
1) Unlock the motor
2) Insert the motor shaft into the drive pulley hole.
3) Lock the motor.
1 CCW (Open) NO Dry contact 4
2 5 Stop - NO Dry contact
3 Ground Common 6 CW (Close) NO Dry contact
Open
my/Stop
Close
DCT Setting tool RTS control point
Wire 100V to 240V
1 Neutral Blue
2 Live Brown
3 Earth Yellow / Green