SOMFY 3.2W Solar Panel, Instructions Manual

Page: 5 / 28

3
EN
Copyright © 2017-2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
5. Use and operating mode
After the
Oximo
40 WireFree™ DC RTS kit has been installed and commissioned, the Somfy battery charges with
electrical energy via the solar panel.
The electrical energy transmitted by the solar panel is stored by the Somfy battery to supply the Oximo 40 WF
RTS motor.
6. Cleaning
Never let snow accumulate on the solar panel and ensure that its photovoltaic cells are not covered by snow,
leaves, etc.
Keep the photovoltaic cells clean by cleaning them with clean water, using a soft cloth to avoid scratching them.
7. Tips and recommendations
7.1 A problem with the 3.2 W solar panel?
Problems Possible causes Solutions
The roller shutter is not operational.
The wiring is incorrect.
Check the wiring and modify it if
necessary.
One of the components (motor, battery,
control point, etc.) is not working.
See the corresponding guides.
The battery is recharged several times
a year using the external battery
charger.
The solar panel is defective or damaged Replace the solar panel.
The battery has reached the end of its
service life.
Replace the battery; see the Somfy battery
guide.
7.2 Replacing a solar panel
A
solar panel must be replaced by a professional, and only with an identical model.
Please separate storage cells and batteries from other types of waste and recycle them via your local
collection facility.
-
Disconnect the solar panel from the motor.
-
Remove the cable from the roller shutter housing.
-
Remove the rivets via the inside of the roller shutter housing.
-
Remove the solar panel.
-
To fit the new solar panel, perform complete reinstallation from section 3.