9
1. Insert stainless steel screws
Insert two M10 x 20 stainless steel screws into each of
the guide rails
2. Insert sliding blocks
Place sliding blocks on the EPO to absorb thermal ex-
pansion. The guide collar points upwards - i.e. towards
the rail!
3. Grease and insert screws
Grease the threads of the self-locking stainless steel
nuts with the lubricant supplied.
Guide the two screws through the sliding blocks and
holes on the anchor point.
4. Fixing the guide rail
Fix guide rail with washer and nut but do not tighten
yet!
5. Connecting the guide rails
Insert the corresponding number of M10 x 20 stain
less steel screws into the next rail. Join the rails using
the connectors and screw them together.
6. Finnishing
Fasten the rail as described under point 1 but do not
tighten it!
Repeat this procedure until the next bend or entry
point.
6. Installation of the guide rails
Fixieren of the guide rail
Connecting the guide rails
Insert screws but do not tighten yet!
Insert stainless steel screws
Insert screws through the sliding blocks
Always grease screws!
If stainless steel screws and nuts
are not sufficiently greased, there is
a risk that the screws will seize in
the threads when tightened.
ATTENTION!
!
