11
1. Insert the fitting pieces
Assemble the fitting piece accordingly. Insert it, move
the rails apart a bit to make it easier and screw them
together with connectors.
2. Tightening the rails on the
anchor point
After all rails have been mounted, align the system so
that it is stress-free.
Then tighten all screw connections (M10 x 20) between
rails and anchor point. The torque for stainless steel
screws M10 strength class 70 is 25 Nm.
Finally, check all screw connections for tightness.
3. Assembly of the entrys and
end stops
Please check the position of the entrys before mounting
them. The entry should be at least 2.5 m away from the
nearest fall edge to allow safe use of the HSS-System.
Every entry or end stop must be fixed on an anchor
point and not protrude more than 30 cm above the last
anchor point.
Entry or endstop may protrude a maximum of 30 cm
Fixing entry / end-stop
Assemble the fitting piece accordingly.
