13
12
Product Overview
1
3
2
5
7
6
4
KEY
1. Max. 1200W zone
2. Max. 1800W zone
3. Max. 1800W zone
4. Max. 1200W zone
5. Glass plate
6. ON / OFF
7. Control panel
TOP VIEW
Installation
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
The power supply should be connected in compliance with the relevant standard,
or a single-pole circuit breaker. The method of connection is shown below.
• If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.
• If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3mm between the contacts.
• The installer must ensure that the correct electrical connection has been made and that
it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced by a properly qualified person.
IMPORTANT!
• The bottom surface and the power cord of the hob should not accessible after
installation is complete.
