9
ASSEMBLY MANUAL
ULTIMATE MODELS 87/83
•
•
Slide part# 9 into parts 5-A & 5-C, and install 1/4” screws (part #8) as shown on the left.
Repeat on the opposite side with 5-B & 5-D.
STEP 3
Check Point 1: Be sure that the screw head is
flush with the extrusion. If not,
Item 2 will not move smoothly.
Check Point 2: The bent tab on Part #9
should both face inward.
Check Point: The bent tab on part #7 should face inward.
•
•
Insert part# 7 into the slots in part # 5-A, B, C, D.
Install 1/4” screw. See the illustration on the left as an example. Look to the exploded
view in
Box Contents
, page 7, for the location of all four slots (two on the top, two on
the bottom).
STEP 4
•
•
•
Attach part # 13/14 to the previously-installed part#
7 using parts # 6 & 10. Do not fully tighten; let part#
13 move freely. Refer to the cross section diagram
on the right.
Repeat this in the remaining five locations where
part # 7&13 were installed.
Install foot pad (part # 12) to protect floors.
STEP 5
5-C
Check Point: FOR TIGHTER CORNERS AROUND FRAME USE SHORTER
L-BRACKETS (PART # 14).
9
5-A
5-C
7
5-C
7
13
7
13
5-C
10
9
9
CONGRATULATIONS!
IF YOU PURCHASED A FREESTANDING SYSTEM YOU ARE NOW COMPLETE
THIS STAGE. BEGIN ASSEMBLING THE BASE NOW. KEEP 2 SETS OF OF PARTS
#10 & 6 HANDY FOR THE FINAL STEP OF FREESTANDING BASE CONNECTION.
*You will have extra parts that are for Doorway/Wall-Mounted/Corner installations.
CONGRATULATIONS!
IF YOU PURCHASED A WALL MOUNT/CORNER SYSTEM YOU ARE NOW
COMPLETE THIS STAGE. IT’S TIME TO ADD THE INSTALLATION BRACKETS.
*You will have extra parts that are for Doorway System.