10
ASSEMBLY MANUAL
•
•
•
•
•
•
•
STEP 7
STEP 8
•
•
•
Measure the inside width of the door frame.
Loosely adjust part# 13 to the door frame width.
OPTIONAL: for tighter corners/wall space, use part #14 on one side.
IMPORTANT:
Step 7 below, start by setting bar in second lowest hole to square
the system.
When centered and squared in front of door, place the brackets to
the frame as squared and flat as possible, hand tighten the screw
and nuts to hold in position. Then, use ONE screw on the middle
right anchor point. This allows for fine tuning adjustments as
needed.
Run the bar up and down to ensure it’s smooth, when bar is locked
in lower holes, screw in top right then top left screws.
STEP 6
WIDTH
DOOR FRAME
ADJUST
Place unit in front of the door frame.
Adjust part # 13 (Door Frame Brackets-long) as needed to ensure that door frame
brackets are placed tight against the door frame. Check all six locations.
TIP: Slide the exercise support bar up and down freequently to space system.
Ensure that unit is centered with respect to the door frame and flat to floor.
Install two wood screws per part # 13 (14 optional) in three locations as shown.
Repeat on the opposite side.
Powerdrill is recommended for best results. Not provided.
Tighten all six nut sets the connect parts # 7 & 13 that were loosely installed in Step 5.
YOU’RE FINISHED!
ULTIMATE MODELS 87/83
13
13
13
