SCG-5608 User Manual Ver. 1.0
- 14 -
⚫
Peer Port
This item is to set the destination port number of the device for TCP connection
and UDP data transmission. It can be set from 0 to 65535, and the default values
are 14700 to 14707.
3.2.3
Advanced
⚫
Connection Timeout (Unit: sec)
This item is to set a timeout for terminating a TCP connection. If there is no
received data during the time set in this item, the TCP connection is terminated.
The unit is seconds and can be set between 0 and 3600. Default value is 0 which
means no termination on the TCP connection.
⚫
Event Count[Byte]
This item is to set the number of bytes for specific event operation for each
connection mode. Default value is 0.
Connection mode
Value
Operation
TCP Server
0
Empty the serial receive buffer
when a new TCP connection is made.
otherwise
(less than 1,024 is
highly recommended)
Send the data in serial receive
buffer to TCP when a new TCP
connection is made.
TCP Client
0
Immediately and repeatedly try to
connect to TCP.
Otherwise
(less than 1,024 is
highly recommended)
Try to connect to TCP when
received byte count is equal or
greater than this value.
Send the data in serial receive
buffer to TCP when a new TCP
connection is made.
Connectionless
(UDP)
0
Does not specify the UDP outgoing
packet size.
Otherwise
(less than 1,024 is
highly recommended)
Specify the UDP outgoing packet
size to this value.
Table 3-2 Event Count
⚫
Option
Item
Description
Default Value
Secure(TLS)
Enable/disable TLS function
Disable
TCP No Delay
Enable/disable TCP No Delay function
Disable
RFC2217
Enable/disable RFC2217 function
Disable
Send MAC ID
Enable/disable sending MAC ID function
Disable
Table 3-3 Option
