CIE-M10A User Manual Ver. 1.0
- 22 -
3.1.2 Configuration via Serial
⚫
Checklists
Make sure of the connection between your PC and CIE-M10A using a RS232 cross
cable. CIE-M10A has to be operating in the [Serial Configuration] mode. You make
CIE-M10A operate in the serial configuration mode by connecting ISP- pin with GND
(LOW) less than 1 second. After then, read the setting on the [Serial] tab.
⚫
Procedures
Figure 3-3 procedures for configuration via serial port
⚫
Step 2, Reading
Figure 3-4 reading procedure via serial
①
Choose the [Serial] tab.
②
Select the COM port which is the device is connected.
③
Open the COM port pressing the [Open] button.
④
Load the setting with the [Read] button.
Refer to the document [ezManager User
s’
Manual] on our website for details.