.29.
.28.
6. Operation
6. Operation
Maintenance or replacement could clear or cause a different value of total energy. Use this
function could allow user to revise the value of total energy to the same value as before. If
the monitoring website is used the data will be synchronous with this setting automatically.
(see Figure 6.20).
Press the DOWN key to move the cursor, Press the UP key to revise the value. Press the
ENTER key to execute the setting. Press the ESC key to return to the previous menu.
6.5.6 Calibrate Energy
Figure 6.20 Calibrate energy
YES=<ENT> NO=<ESC>
Energy:0000000kWh
6.5.7 Special Settings
This
function is applicable by maintenance personnel only, wrong
operation will prevent the inverter from working properly.
6.5.8 STD. Mode Settings
There are 5 setting under STD. Mode settings.
1. Working mode 2. Power Rate limit 3. Freq. Derate set 4. 10mins OV-G-V set.
5.Initial Settings
This
function is applicable by maintenance personnel only, wrong
operation will prevent the inverter from working properly.
6.5.9 Restore Settings
The
screen
shows
as
below
:
Figure 6.21 Restore Settings
Are
you
sure
?
YES=<ENT> NO=<ESC>
Press
the
Enter
key
to
save
the
setting
after
setting
grid
off
.
Press
the
ESC
key
to
return
the
previous
mean
.
Restore setting could set all item in 6.5.7 special setting to default.
6.5.10 HMI Update
This function is used for update the LCD program.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
6.5.12 Restart
HMI
6.5.13 Debug Parameter
This function is used for manufacturer maintenance personnel only.
The
function
is
used
for
restart
the
HMI
.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
6.5.14 DSP Update
The function is used for update the DSP
.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
6.5.12 External EPM Set
This setting should only be turned on when Solis external EPM device is used.
Two options are available
：
5G-EPM and Others-EPM.
Figure 6.22
->5G-EPM
Others-EPM
5G-EPM Failsafe Option should be turned ON when 5G series EPM device is used
Others-EPM Failsafe Option should be turned ON when 2G series EPM device is used
Only one option can be activated each time.
