77
76
STEP 9:
●
When you start using the appliance and fi ll the vegetables / the fruits into the
funnel on the top, use the tamper to slowly push the vegetables resp. the fruits
downwards. Take care to push the tamper down slowly and gently. Too much
force does nothing to speed up the juicing process and might even damage the
appliance. Only use the tamper to push down on the vegetables / the fruits.
Never insert any other objects or your hand into the funnel!
●
Note:
The 3 guide rails in the tamper have to be positioned above the nibs
in the funnel so that the tamper can easily slide down. The widest guide rail
should be positioned in front, above the rotary control, as the nib in the front
is the largest. If the widest guide rail is not positioned above the rotary control,
you might experience problems when pushing the tamper down or lifting it up.
▲
DISASSEMBLING THE JUICER
STEP 1:
●
Pull the pomace container out of the appliance. Remove the juice jug.
STEP 2:
●
Open the clasp by folding it over the renitency and down to the right.
STEP 3:
●
Lift the juicer cover with the tamper off the juicer bowl.
STEP 4:
●
Lift the juicer bowl together with the inlying sieve off the motor unit. When
lifting both parts off together, you avoid injuring yourself with the sharp sieve.
To do that, fi rmly yank the juicer bowl up to separate it from the motor unit.
After that, you can turn the juicer bowl upside down so that the sieve falls out.
Make sure that the sieve does not fall from high up, as this will damage the
sieve as well as the surface beneath. Alternatively, you can fi rst remove the sieve
from the juicer bowl by fi rmly pulling it up and out. When doing this, you must
only hold the sieve by the upper edge, as the grinding blades in the sieve are
extremely sharp and must never be touched! Then, the juicer bowl can be easily
lifted off the motor unit.
▲
BEFORE FIRST USE
●
Before using your juicer for the fi rst time, remove all potential advertisement
stickers and labels (except for the type plate).
●
Take the appliance apart as described in the section
“Disassembling the juicer”
(see above).
●
Rinse all juicer parts except the motor unit with warm (not above 50 °C) water
and some detergent. Please be very careful not to injure yourself with the sharp
grinding blades in the sieve. For the sieve, best use the supplied cleaning brush.
Dry all parts carefully.
●
Wipe the motor unit clean with a soft, slightly moist towel.
●
When all parts are completely clean, assemble the juicer as described in the
section
“Assembling the juicer”
(see page 72 – 75).
GB
GB
