00-WTS-DB REV 1 11/2005 Solidyne Corporation 4215 Kirchoff Road Rolling Meadows IL (800) 648-3980 www.solidyne.com
Solidyne
1
TECH/DATA SHEET
WTS-DB
Revision 1 12/2007
WTS-DB Digital Room Temperature Sensor
The WTS family of Wall Temperature Sensors are designed to be
used with the M2 family of Solidyne controllers. They are designed
with a rugged anodized aluminum housing and a unique one screw
attachment to it’s base plate.
The WTS-DB is a digital wall mounted room temperature sensor with
multiple modes of operation. It uses LED’s to display room tempera-
ture along with room setpoint and zone override. It also has a built
in light sensor which can be enabled or disabled. The WTS-DB wires
to the M2 family of controllers via CAT-5 cabling and does not have
options for hard wiring.
Specifications
Input Power: Supplied by M2 controller
Temperature Input: 10k Thermistor (Type III)
Operating Temperature: +23°F to +150°F (-5°C to +66°C)
Storage Temperature: -40°F to +230°F (-40°C to +110°C)
Operating Humidity: 10 to 95 %RH non-condensing
Storage Humidity: 10 to 95 %RH non-condensing
Physical Dimensions
WTS-DB Housing:
WTS-DB Backplate:
Wiring
The WTS-DB must be wired to an M2 family controller via the
CAT-5 connection on the back of the device. This method uses
any straight through CAT-5 cable. See figure 3 for the proper
RJ-45 crimping polarity. One end of the CAT-5 cable terminates
into either of the two RJ-45 female connectors on the back of
the WTS-DB. The other end will terminate into the middle M2
RJ-45 female connector. When the WTS-DB is wired via this
method, the temperature sensor input will automatically use
Input #1 (AI1) of the M2 controller that it is attached. The
zone setpoint input will automatically use Virtual Input #1 (VI1)
and the light level sensor will use Virtual Input #2 (VI2) on any
M2 family controller.
Figure 1
Figure 2
Figure 3