Solidator 1.0, User Manual

Page: 9 / 19

9
Note: The projector has a zoom and a focus wheel for projector calibration
8. Put the red cover back on the Solidator. Notice that the cover has a magnet inside and that
this magnet needs to sit on inside-rear-right side of the red cover (printer viewed from the
front).
9. Please click on “Setup” and then select Calibrate → Motor, then press Start.
10. After this action, the motor will drive the printing plate to a position that aligns with the top
edge of the resin container. Remove the red cover and confirm that the top of the container
matches the lower edge of the print platform. Then put the red cover back again and press OK
to drive back up.