Solidator 1.0, User Manual

Page: 5 / 19

5
Selecting a Good Location for Your Solidator Printer
When planning where to position the Solidator, you should select a location that fits the follow criteria:
Well ventilated environment (at a minimum forced ventilation on demand), as the resin and alcohol for
cleaning emit an odor.
Ideally, position the Solidator on a table strong enough to hold about 50 kg
(110lb)
of weight.
It is recommended to place the Solidator on a laminated work surface or one that has been
treated to be resistant to household chemicals. To verify that the resin will not damage the work
surface, place a small amount of resin on a small inconspicuous area and verify that the surface is
not damaged. Also make sure the table is not vibrating.
Note that the Solidator is a WiFi and Ethernet-enabled device, so you can locate it in a room
other
than your PC workplace.
Important: There should be no direct sunlight or strong lamp shining in to the Solidator Red Cover
or onto the back side of the Solidator.
After you have selected the location to setup your
Solidator, please test the environmental lighting by placing a small amount of resin in a
clear container and expose to the existing lighting. If the resin does cure (solidify),
consider either moving the Solidator to another location or make adjustments to the
lighting to minimize interaction with the resin.
After you selected the location where to put the Solidator, please put small amount of resin in a
small container to test if the resin cures from the light in that room – or not.