Page 40
Duality
F
use Installation & Setup Guide
Setting Up Your DAW
Section 5
Assigning Duality’s Fixed IP Address
An alternative fixed IP address can be set using the console’s diagnostic port. You will need a PC or Mac running terminal
emulator software. Connect your computer’s serial port to Serial Port 2 on the rear of the console using a 9 way ‘D’ type
extension cable. The pin-out for Serial Port 2 is shown on page 56.
Set the terminal configuration as follows:
Baud rate 19200, 8 data bits, No parity, No start bit, 1 stop bit, Flow control Xon/Xoff
Press the ‘Return’ key (<CR>) and the terminal window should echo a ‘>’ if communication is established.
To fix the IP address type the following:
ip <CR>
setip nnn nnn nnn nnn <CR>
Where ‘nnn...’ is the IP address, 192.168.1.2
setmask nnn nnn nnn nnn <CR> Where ‘nnn...’ is the subnet mask 192.168.1.1. Note that this should match other
devices local to the console.
setgate nnn nnn nnn nnn <CR> Where ‘nnn...’ is the gateway address e.g. ‘10 1 1 1’
Network trouble shooting
Most Ethernet adaptor cards have two leds associated with each port. The first indicates that the link is connected and
the second indicates network traffic. Please note that some Macintosh computers do not have external leds to indicate
status. Instead the link status is shown in the System Preferences/Network menu.
On your host workstation computer, confirm that the link led is permanently illuminated. If it is not permanently
illuminated, it suggests you have a cabling error. In this instance please check the following:
• The RJ45 network connector on the console and on your workstation are fully inserted.
• If you are using a pin-pin cable to make a direct connection between your console and workstation, try replacing it
with a crossover cable
• Try replacing the network cable
• If you are not using a direct connection between your console and workstation using the default fixed IP address on
the console, please try this simple configuration to rule out issues with external routers and network switches. If the
link led is illuminated, the next step is to confirm that the activity led is illuminating periodically to show network
traffic. If it does not illuminate periodically check the following:
• If your workstation is not connected directly to your console using a crossover RJ45 cable and fixed IP addressing,
follow the installation instructions to configure this simple network configuration to rule out issues with any external
routers or network switches.
• Using the fixed default IP address on the console, check that the workstation has basic communications using ‘ping’.
Under Windows – Select: ‘Run’ under the ‘Start’ menu. In the resulting window enter ‘cmd’ to launch the command prompt.
In the command prompt window enter ‘ping 192.168.1.2’
On OSX: Open a Finder window, select Applications, then Utilities, and double-click on Terminal. In the terminal window
enter ‘ping –c4 192.168.1.2’
In both cases your host computer will try to establish communications with your console. In the resultant terminal text,
check that the console responded to every message sent by your workstation.
Summary of Contents for Duality Fuse
