Solid State Logic C200 routing guide, Installation Manual

Page: 49 / 80

Installation Wiring
Section 5
Page 45
Meters and Phasescope
The Centre Section of the C200 console is fitted as standard with four off analogue VU meters.The meters supplied are
for Left, Right, Mono and Phase signals. Note that only analogue feeds of Left and Right audio need to be provided as the
Mono and Phase signals are derived internally to the console.
In addition, the Centre Section may optionally be fitted with an LCD phasescope. Two standard phasescope types are
available, the MSD600C or the RTW 10830. Other custom meter solutions may be possible.
Cable connections to the meters and phasescope will need to be run between the Centuri and the Console. Both balanced
analogue and 110Ω digital cables may be necessary depending on configuration.These cables are not supplied by SSL.
The MSD600C 5.1 phasescope has inputs for 6 digital signals (3 AES/EBU pairs), plus a serial diagnostic port.
The RTW 10830 has eight digital input signals, eight digital output signals, eight analogue input signals plus a remote control
port. Note that two of the analogue input signals will normally also feed the L and R mechanical meters.
The Analogue meters could be parallel feeds from the console main output signals or, alternatively, independent feeds from
the analogue output card.