PRODUCT MANUAL
NeonMax 24V 85W
Toll Free. 425-582-7533
www.SolidApollo.com
page 2
™
Proper Cutting and Installation
Figure 1.
Tools & Accessories Required
This section will guide you on how to cut the NeonMax, install a power/extension cable, and add an end cap for a complete, fully
waterproof connection. Please note, for outdoor or high humidity applications, we recommend using waterproofing glue for all
connections and a drying time of at least 24 hours before installing or using the NeonMax.
Sharp Metal Scissors or Shears (for cutting Neon at cut points)
5g Waterproofing Glue
Soldering Iron
15ft Waterproof LED Strip Extension Cable
Cable End Cap for NeonMax 24V 85W
Box Knife or Blade
Look on both sides of the NeonMax strip and find the side that has a thin transparent
line in the middle of the strip. The transparent line will be your guide to locating the
strip’s cut points.
Within the transparent lines you will see a distinctive small
black line
. That black line
is your cut point (see Figure 1).
Pro Tip:
The NeonMax has cut points every
2 inches
. If you are having a hard time
seeing the Cut Points, measure 2 inches from the beginning of the Neon Strip, mark it
with a marker and cut it from there.
Imagine a line passing from one side of the NeonMax to the other with the center being
the cut point symbol. Take either
scissors
or
shears
and line them up over the cut point
as straight as you can and cut through the NeonMax (see Figure 2).
Step 1:
Locate the Cut Points
Step 2:
Cutting the Cut Point
Figure 2.
