12
INSTALLATION—SLIDING
INSTALLING THE UNIT IN A SLIDING WIN-
DOW (CONT.)
13. Cut side channel seal
into 2 equal lengths.
Remove protective backing and apply it to the rear
side of cabinet side channels, starting just below
panel frame assembly. Pinch off excess length so
seal is even with the bottom of the cabinet side
channel.
14. To remove front
1. Remove the two front retaining screws from the
front frame.
2. Press firmly on each side of the metal case close
to the front, approximately 2/3 of the way down.
3. While pressing on the sides of the metal case,
gently pull the front out and lift up to release it
from the case.
4. Then remove the four screws from the front frame
to release the control panel box.
NOTE:
DO NOT push or pull air direction louvers.
15. Place AC in window opening.
As shown right, it
should sit on platform assembly so that window
panel frame, and cabinet side channels are against
top and side window jambs. (continued)
