INSTALLATION GUIDE
KM SERIES MICROWAVE LINK
36
Rev 1.1
4.
Thread the fiber optic cable through all components of Gland M20 (cap,
seal, body and washer), and the reducer as follows:
5.
For properly inserting the cable through the seal, push down each wire
through each slit in the seal as illustrated below:
6.
Once the SFP module is installed in the radio, insert the fiber optic cable’s
end in the radio’s SFP port until hearing a click.
7.
Screw-in the reducer with O-Ring onto the Radio until it is firmly seated.
8.
Screw-in the body and washer onto the reducer until firmly seated.
9.
Slide the seal into the body, then tighten the cap onto the body until it is
firmly seated.
10.
The proper assembly should look as follows:
11.
Apply self-sealing tape around the connector assembly covering the entry
point of the cable to the gland.
Wire forced through slit
Seal fully inserted
Final position