8
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic costing and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 44
℉
(7
℃
). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
AVOID LOCATING THE UNIT IN MOIST AREAS.
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize
the possibility of electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord
supplied. For personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC~60Hz with a 15 Amp Dedicated Circuit and three-
prong grounded electrical outlet. Have the wall outlet and circuit checked by a qualified electrician to
make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is
your responsibility and obligation to have it replaced with a properly grounded.
Ground fault circuit interrupters (GFCI) are prone to nuisance tripping which will cause the unit to
shut down. GFCI’s are generally not used on circuits which power equipment that must run
unattended for long periods of time, unless required to meet local building codes and ordinances.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
The appliance should always be plugged into its own individual electrical outlet which a voltage
rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits that could cause a fire hazard from overheating. Never
unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out
from the receptacle. Repair or replace immediately all power cords that have become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damaged along its length or at
either end. When moving the appliance, be careful not to damage the power cord.
This appliance includes an optional stainless steel handle. To
install the handle, follow these instructions:
1. Use a screwdriver to remove the screws on the door where
the handle is to be installed.
2. Align the handle with the screws removed in step 1. Tighten
the screws using a Phillips head screwdriver until the handle is
both flush and secured tightly against the door side. (DO NOT
over-tighten as this will cause damage to the stainless steel
door surface.)