SB900
INDOOR CYCLE
10
6
TABLET
HOLDER
1.
Install the Tablet Holder (
138
) on the Handlebar (
6
) with 3pcs of 4 x 16mm
Sheet Metal Screws (
101
) by using the M5_Combination M5 Allen Wrench &
Phillips Head Screw Driver (
86)
INSTALL / REPLACE SENSOR TRANSMITTER BATTERIES
1.
Remove the left cover (
112
) by removing four screws (
30
) and two screws (
93
).
2.
Without removing the transmitter from the left cover (112), remove the Battery Cover from the
transmitter.
3.
Install 2 AAA batteries in the battery compartment and reinstall the battery cover.
4.
When new batteries are installed in the transmitter or console you must perform the
synchronizing procedure below for the console to work properly
5.
After synchronizing, make sure the wire from transmitter is wrapped around the plastic as in the
above image.
6.
Reinstall left cover.
HARDWARE
STEP 6
#101
. 4 × 16mm
Sheet Metal Screw
(3 pcs)
Summary of Contents for SB900
