Dyaco Canada Inc. 2013
12
#120
. M5 x 15mm
Phillips Head Screw
(7 pcs)
#122
. Ø3.5 x 12mm
Sheet Metal Screw
(8 pcs)
#100
#100
#100
#100. Swit
ch Wire Cap
(2 pcs)
4
PLASTIC
PARTS
HARDWARE STEP 4
1.
Connect Swing Arm Wire (Lower), Resistance/Incline (
50
) , Swing Arm
Wire(Upper), Incline (
49
) and connect Swing Arm Wire (Lower),
Resistance/Incline(
50
) , Swing Arm Wire (Upper), Resistance (
48
). Push
the excessive wires into the Console Mast and plug in the Switch Wire
Cap (
100
) at each side on the Mast .
2.
Attach front (
89
) and rear (
90
) Handle Bar Covers together on left Swing
Arm shaft and secure using two Sheet Metal Screws (
122
) and the Phillips
Head Screw Driver (
150
). Repeat this process for the right side Handle
Bar Covers (
91
) and (
92
).
3.
Install Console Mast Covers (
L & R
) (
81 & 82
) on each side of the Side
Cases and secure with two Sheet Metal Screws (
122
) and the Phillips
Head Screw Driver (
150
).
4.
Secure left Slide Wheel Cover (
87
) on left Pedal Arm with two Phillips
Head Screws (
120
) by using Phillips Head Screw Driver (
150
). Repeat
this process for the right Slide Wheel Cover (
88
).
5.
Secure Console Chin Cover (Front) (
93
) on the Mast and then match with
Console Chin Cover (Rear) (
94
). Secure the covers with three Phillips
Head Screws (
120
), two Sheet Metal Screws (
122
) and the Phillips Head
Screw Driver (
150
).
6.
Snap Rear Bar Cover (
97
) into the hole on the Incline Rail Assembly.
ASSEMBLY
STEP
4
