Customer Service 1-888-707-1880 Dyaco Canada Inc. 2014
email: [email protected]
17
PULSE GRIP FEATURE
The
Pulse
(Heart Rate) window will display your current heart rate in beats per minute during the
workout. You must use both left and right stainless steel sensors on the front cross bar to pick up
your pulse. Pulse values are displayed anytime the computer is receiving a Grip Pulse signal or
while wearing an optional chest strap transmitter (see Using the Heart Rate Transmitter section
for directions). You may use the Grip Pulse feature while in a Heart Rate Program (
HR1
or
HR2
).
TURNING OFF TREADMILL
1. The display will automatically turn off – go to sleep - after 30 minutes of inactivity
when in the Pause / Stop mode. Almost all power for the treadmill will be off except
for some circuits that are needed to detect if any key is pressed, indicating the
console should “wake up”. When the console is “asleep” the treadmill draws very little
power, about as much as your television when it is turned off.
2. Removing the safety key is similar to entering “sleep” mode. Turning off the main
power switch in the front of the treadmill will completely remove any power.
3. To exit the display mode, for normal operation, press and hold the
Stop
/
Enter
/
Display
keys for 5 seconds; the display will show
Display Mode - ON
.
Use the speed Up key to change the setting to OFF then press
Enter
.
**ATTENTION**
Your new console comes configured in an in-store ‘display mode’ of operation, where the
console will remain powered on unless the main power switch is turned off. To exit the
display mode, for normal operation, press and hold the
Stop
,
Enter
and
Display
keys for 5
seconds; the display will show: Display mode - On. Use the
Up
arrow or
Fast
key to change
the setting to Off then press
Enter
.
