Systems and scheduled
maintenance
Solé, S.A. C-243 b, km 2 · 08760 Martorell (Barcelona) ·Tel. +34 93 775 14 00 · www.solediesel.com · [email protected]
36
Marine diesel engines. Operator’s manual
Maintenance task. V-belt replacement
In the event that replacement of the belt (s) is required, carry
out the following procedure:
Fully distension old belt so that is removal can be made easier.
Fuel pump
1.
To adjust the belts, loosen the screws (1) and (2). Push the
fuel pump (3) to the left until the belt is correctly tensioned.
Tighten the screws.
2.
To change the belts. Loosen the screws (1) and (2). Push
the fuel pump (3) to the right. Remove the belt and replace
it with a new one. Push the fuel pump (3) to the left until the
belt is correctly tensioned. Tighten the screws.
Alternator
1.
To adjust, loosen the screw (2). Push the alternator belt
pulley (1) to the right until the belt is correctly tensioned.
Tighten the screws.
2.
To change the belt. Remove the belt for the fuel pump. Loosen the screw (2). Push the
alternator belt pulley (1) to the left and remove the belt. Replace it with a new one. Push
the alternator belt pulley (1) to the right until the correct belt tension. Tighten the screw
(2).
2.
When the belt is unfitted, check the condition of the pulley recesses, they shall be dry
and clean. Its cleanliness is performed with soap water (never use petrol, gas oil or
similar products).
3.
Fit the belt taking care the belt insertion is made with the hand but without damaging it
and if required pace it with a tool at least without any cutting edges since otherwise the
belt could be damaged and its life shortened.
4.
The belt shall be tensioned such as is previously explained.
Always change a belt that appears worn or is cracked. Belts working in pairs be replaced together.
Maintenance task. Battery level
Battery requires a very careful handling and frequent checking. Proceed as shown below:
1.
Keep battery dry and cleaned.
2.
Check terminal cleanliness regularly. If dust is settled, terminals should be loosened,
cleaned and smeared with a neutral grease layer.
3.
Metal objects must not be placed over the battery.
4.
Add distilled water if the level is out of range
