4
Installation
4.1
Installation Prerequisites
When assembling the system, avoid touching the battery terminal with any metal
objects or human body. T-BAT SYS-HV provides a safe source of electric energy
when operated as designed. Potentially hazardous circumstances such as
excessive heat or electrolyte leakage may occur under improper operating
conditions, damage, misuse and abuse. The previous safety precautions and the
warning messages described in this section must be observed. If any of the
previous precautions are not fully understood, or if you have any questions,
contact customer service for guidance. The Safety Section may not include all
regulations for your region.
Make sure that the installation location meets the following conditions:
Ÿ
The building is designed to withstand earthquakes
Ÿ
The location is far away from the sea, to avoid salt water and humidity
Ÿ
The floor is flat and level
Ÿ
There are no flammable or explosive materials nearby
Ÿ
The ambience is shady and cool, keep away from heat and avoid direct
sunlight.
Ÿ
The temperature and humidity stays at a constant level.
Ÿ
There is minimal dust and dirt in the area.
Ÿ
There is no corrosive gases present, including ammonia and acid vapor.
Note!
If the ambient temperature is outside the operating range, the battery
module stops operating to protect itself. The optimal temperature
range for the battery module to operate is 15°C to 30°C. Frequent
exposure to harsh temperatures may deteriorate the performance and
lifetime of the battery module.
4.2
Safety Gear
Installation and maintenance personnel must operate according to applicable
federal, state and local regulations as well as the industry standards regarding the
product installation personnel shall wear safety gears, etc. in order to avoid short
circuit and personal injury.
Insulated gloves
Safety goggles
Safety shoes
4. Installation
12
13
4. Installation
4.3
Tools
These tools are required to install the T-BAT system.
Torque screw driver
Phillips-screw driver
Hexagon wrench
Phillips-head screw driver
Flat-head screw driver
Torque wrench
Tape measure
Drill
Pencil or Marker
4.4
Installation
4.4.1
Check for Transport Damage
Make sure the battery is intact during transportation. If there are some visible
damages, such as cracks, please contact your dealer immediately.
4.4.2
Unpacking
Unpacking the battery package by cutting the packing tape and make sure the
battery modules and the relevant items are complete. See package items on
section 4.4.3, please check the packing list carefully, if there's any item missing,
please contact SolaX or your distributer directly.
Caution!
According to regional regulations, several people may be required for
moving equipment.
12
Warning!
Please strictly follow the installation steps. SolaX will not answer for any
hurting or loss arising by incorrectly assembling and operation.
