4
LOG SET INSTALLATION
Step #8
Install the single rock on the 2 pins located on the far left of the burner top. The log-locating tab on top
of the rock should be toward the back of the burner. (Figure 10)
Step #9
Install the center birch log by placing the left side of the log on the locating pin left of the pilot. The right
side of the log will rest on top of the 3-rock cluster, rotate the log so it gently touches the rear enamel
panel of the firebox. (Figure 11)
Step #10
Evenly distribute the included 13oz of lava rock on the exposed burner top. Cover the burner top
completely but do not compress or “pack” the lava rock tightly. Pay special attention to tight and hard
to reach areas when placing the media on the burner. It is ok if small amounts of lava rock are lost over
the edge of the burner. (Figure 12)
FIGURE 10
FIGURE 11
FIGURE 12
