SÓLAS
CONTEMPORARY FIRE
2
KIT CONTENTS:
• (1) CERAMIC LOGS
• 7oz. LAVA ROCK
• (1) CERAMIC ROCKS
• METAL LOG SET BURNER
LOG SET INSTALLATION
SÓLAS BIRCH LOG SET
BURNER SUPPORT LOCATIONS
Unless the ONE6 Direct-Vent Gas Fireplace was originally ordered with the Birch Log Set, your
fireplace will have shipped from the factory with a Glass Media burner in place. Before installing the
log set burner, you will need to remove the glass burner. See following steps 1-4 to remove the Glass
Media burner. If the fireplace has been ordered with the Log Set Burner, you can skip to
Figure 10 –
“INSTALLATION OF BIRCH LOG SET”
on Page 4 of this manual.
1. The burner is held in place by 4 sheet metal screws, 2
on the left and 2 on the right. To make access to these
screws easier, we are going to loosen the valve bracket
so it can be moved slightly. Figure 1 shows the screw
on the left under side of the firebox securing the back
of the valve bracket, remove this screw. Keep this screw
in a safe place as it will be needed to secure the valve
bracket again once the logset burner is installed.
REMOVAL OF GLASS MEDIA BURNER
Figure 1
