SÓLAS
CONTEMPORARY FIRE
4
LOG SET INSTALLATION
STEP 1
Install the logset burner within the firebox by lowering
the burner into the firebox (while keeping the burner
pressed toward the right side of the firebox) then
sliding the burner left towards the center of the firebox
to engage the burner orifice as shown in figure 10.
Confirm that the burner inlet tube has engaged the
burner orifice. (Figure 10)
STEP 2
Secure the burner using the (4) #10 sheet metal screws
set aside from steps 4 & 5
STEP 3
Secure the valve bracket using the (2) #10 sheet metal
screws set aside from steps 1 & 2.
STEP 4
Install the 3-rock cluster on the 2 pins located just right
of the pilot. (Figure 11)
Figure 10
Figure 11
> Start HERE if the ONE6 Wall-Mount was originally ordered with a Log Set Burner
NOTE: The log set burner can be configured for either
Natural Gas or Propane by installing or removing a collar
on the burner venturi. Figure 8 shows the venturi inlet with
the collar installed on a burner configured for Natural Gas.
Figure 9 shows the venturi inlet with the collar removed
from a burner configured for Propane. THIS VENTURI IS
NOT ADJUSTABLE. If you need to convert your burner
from Propane to Natural Gas or vice-versa, please order
the appropriate conversion kit for your appliance.
INTALLATION OF BIRCH LOG SET
Collar OFF for LP
Collar ON for NG
Figure 8
Figure 9
