For use with LoCor paper towels only (SKU numbers 46896, 46897, 46898,
46899, 46901 and 46902). Other types of paper are not acceptable.
Paper should be loaded with paper “tail” unwinding from the front of the
roll. After the paper roll is loaded correctly into the dispenser, pull the paper
“tail” downward and tuck it under the tension rol
ler
. Turn the assist wheel in
the clockwise direction until the paper “tail” comes out at the bottom of the
dispens
er.
The dispenser is now ready for
dispensing. Simply pull the paper
“tail” at the bottom of the
dispenser to obtain paper.
a. If there is no paper “tail” at the bottom of the dispenser, turn the assist
wheel in the clockwise direction until the “tail” comes out.
If there is still no paper “tail” after two rotations of the assist wheel, open
the dispenser cover for further examination.
If the assist wheel gets stuck, do not force it to turn. Open the dispenser
cover for further examination.
b. If the dispenser performs poorly (not cutting or only partially cutting
paper), open the dispenser cover for further examination:
Check to ensure that paper roll is loaded correctly
Check to ensure that the Roll Supports are installed at the correct places.
Re-load the paper roll: first tear the paper from the roll at the section
before the paper enters the mechanism, then
remove the remaining paper
out the bottome of the dispenser.
Turn the assist wheel several times to
insure that the mechanism is moving smoothly. Next, re-load the paper as
instructed in section 4 – Paper Roll Loading and Start-up.
For further assistance, please contact technical dispenser support at (920) 940-8904
Ensure the paper tail is in the
opening o
n
the cover for
proper dispensing.
8778002
Released January
8
201
8
9
I
V
.
PAPER ROLL LOADING AND START-UP
V
.
DIAGNOSTICS
Figure
11
.
